NEC NP-L102W Manuale Utente

ProjectorL102WUser’s ManualModel No.NP-L102W

3... EnglishUsage Notice Do: Turn off the product before cleaning. Use a soft cloth moistened with mild detergent to clean the cabinet. Disc

4English ...IntroductionProduct Features This product is a WXGA single chip 0.45” DLP® projector. Features you’ll enjoy: Light and small LED project

5... EnglishIntroductionPower Cord x1 Computer Cable (VGA)(P/N:79TC5061)Remote Control(P/N:79TC5091)Battery (CR2025)ProjectorPackage OverviewThis proj

6English ...IntroductionVentilation (intake)1. Ventilation (exhaust)2. Remote Sensor3. Speaker4. Lens Cover5. Lens6. Control Panel7. Focus Lever8. Pro

7... EnglishIntroductionConnection PortsSD CARD Slot1. Used for Multimedia.Insert the SD card into this slot with the label facing up. Note:Supported

8English ...IntroductionControl Panel1 2431 STATUS indi-catorIndicate the projector’s tempera-ture status and Control Panel Lock is enabled. Refer to

9... EnglishIntroductionRemote Control1 POWER Refer to the “Power On/Off the Projector” section on pages 14-152 VOL. +/- Increase/decrease speaker vo

10English ...Introduction6 SD Press “SD” to choose the SD CARD slot. Multimedia will start.7 USB-A Press “USB-A” to choose the USB-A port. Multimedia

11... EnglishIntroductionBattery InstallationRemote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it

12English ...Installationm o l e xMOLEXE62405SPRConnecting the Projector1...

Ver.1/12/2013• DLP, DLP logo, DLP Link, and BrilliantColor are trademarks or registered trademarks of Texas Instruments.• IBM is a trademark or regi

13... EnglishInstallationE62405SPRAudio OutputDue to the differ-ence in applications for each country, some regions may have differ-ent accessories.

14English ...InstallationPowering On the Projector1. Slide the lens cover. 2. Ensure that the power cord and signal cable are securely connected.

15... EnglishInstallationPowering Off the Projector1. Press the “POWER” button on the remote control or the button on the control panel to turn o

16English ...InstallationWarning Indicator When the “STATUS” indicator ashes red in two cycles, it indicates the projector has overheated. The pro

17... EnglishInstallationAdjusting the Projected ImageAdjusting the Height of Projector ImageThe projector is equipped with an adjustable foot to rais

18English ...InstallationFocus LeverAdjusting the Projector FocusAdjusting Projection Image SizeTo focus the image, rotate the focus lever until the i

19... EnglishUser ControlsThe Projector has a multilingual On Screen Display (OSD) that allows you to make image adjustments and change a variety of s

20English ...User ControlsMenu Tree Main Menu Sub MenuPicture Mode Presentation / High-Bright / Video / Movie / sRGB / Blackboard / Color Extension /

21... EnglishUser ControlsMain Menu Sub MenuSettingsInput Search Off / OnFan Mode AUTO / High SpeedEco Mode Off / OnInformation Hide Off / OnBackgroun

22English ...User Controls Picture ModeThere are many factory presets optimized for various types of im-ages. Use the or button to select the ite

iEnglish ...Important InformationSafety CautionsPrecautionsPlease read this manual carefully before using your NEC projector and keep the manual handy

23... EnglishUser Controls ContrastThe contrast controls the degree of difference between the lightest and darkest parts of the picture. Adjusting th

24English ...User ControlsIMAGE | Advanced GammaThis allows you to choose a gamma table that has been ne-tuned to bring out the best image quality f

25... EnglishUser Controls InputUse this option to enable / disable input sources. Press to enter the sub menu and select which sources you require

26English ...User ControlsSCREEN Aspect RatioUse this function to choose your desired aspect ratio.  AUTO: Automatically selects the appropriate dis

27... EnglishUser ControlsSCREEN | 3D Settings 3D Off: Choose “Off” to display normal (2D) picture. On: Choose “On” to display 3D format. 3D Inver

28English ...User ControlsSETTING LanguageChoose the multilingual OSD menu. Press the or button into the sub menu and then use the or button

29... EnglishUser ControlsStandard V FlipH Flip H+V Flip Menu LocationChoose the menu location on the display screen. SignalRefer to next page. Mut

30English ...User ControlsSETTING | Signal (RGB) Phase Synchronize the signal timing of the display with the graphic card. If the image appears to b

31... EnglishUser ControlsSETTING | Advanced LogoUse this function to display the startup screen (NEC logo). On: Displays the NEC logo. Off: No log

32English ...User Controls Input Search On: The projector will search for other signals if the current input signal is lost.  Off: The projector wi

iiEnglish ...Important InformationRF Interference (for USA only)WARNINGThe Federal Communications Commission does not allow any modications or change

33... EnglishUser Controls InformationRefer to next page. AdvancedRefer to page 35. ResetChoose “Yes” to return the display parameters on all menus

34English ...User ControlsOPTIONS | Information InformationTo display the projector information for source, resolution, and software version on the s

35... EnglishUser ControlsOPTIONS | Advanced Direct Power OnChoose “On” to activate Direct Power mode. The projector will automatically power on when

36English ...User ControlsMultimedia is an interactive PC-less presentation solution. It equipped several mode (Photo, Video, Music, Ofce Reader, and

37... EnglishUser ControlsHow to operate 1. To open the OSD, press the MENU button on the remote control.2. When OSD is displayed, use the but

38English ...User ControlsMultimedia Menu Tree Level 1 Level 2 Level 3 Level 4SettingsPhoto Setup Display Ratio Auto/FullSlideshow Duration5 sec./15 s

39... EnglishUser ControlsSupported Formats Supported graphic formats:JPG, BMPJPG le supports JPEG Baseline and progressive JPEG.BMP le supports

40English ...User ControlsRestrictions on displaying Microsoft Ofce les and PDF lesThe Ofce Reader allows you to give a simplied display of a Mic

41... EnglishUser ControlsUsing the Projector as a Storage DeviceImportant:• Use the projector’s storage area as a temporary storage.Back up your dat

42English ...User ControlsNote:• Wait at least 5 seconds after disconnecting a USB memory device before recon-necting it and vice versa. The computer

iiiEnglish ...Important Information Fire and Shock Precautions • Ensure that there is sufcient ventilation and that vents are unobstructed to prev

43... EnglishUser ControlsProjecting Your Computer’s Screen Image from the Projector via the USB Cable (USB Display)Using a commercially available USB

44English ...User ControlsWireless ProjectionThe optional Wireless LAN Unit (NP03LM/NP02LM) allows you to send your computer screen, photos or les (M

45... EnglishAppendicesProblem: No image appears on screen Ensure all the cables and power connections are correctly and securely connected as descr

46English ...Appendices 6. Click on “Show all devices”. Next, select “Standard monitor types” under the SP box; choose the resolution mode you need

47... EnglishAppendicesProblem: Image is out of focus Adjust the Focus Lever on the projector lens.  Make sure the projection screen is between the

48English ...AppendicesProblem: Indicator lighting messagePower IndicatorIndicator Condition Projector Condition NoteOff The main power is off --Blink

49... EnglishAppendicesSpecicationsModel Number NP-L102WOpticalProjection System Single DLP® chip (0.45”, aspect ratio 16:10)Resolution *11,039,680 p

50English ...Appendices*4 HDMI® (Deep Color) with HDCP What is HDCP/HDCP technology? HDCP is an acronym for High-bandwidth Digital Content Protection

51... EnglishAppendicesCompatibility ModesSignal Resolution (dots)Aspect Ratio Refresh Rate(Hz) VGA 640x480 4:3 60/72/75/85SVGA 800x600 4:3 56/60/72/7

52English ...AppendicesSignal Aspect Ratio Refresh Rate(Hz)NTSC 4:3 60PAL 4:3 50PAL60 4:3 60SECAM 4:3 50Composite Video  TIP:• An image with any re

ivEnglish ...Important Information Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry

53... EnglishAppendicesTripod Stand Installation1. You can install this projector using a camera tripod.2. The tripod specications:  Type: 1/4”-20

54English ...AppendicesCabinet DimensionsLens Center238.3/9.38”177.4/6.98”43.5/1.71”46.4/1.83”49.0/1.93”51.8/2.04”51.9/2.04”53.4/2.10”23.8/0.94”167.6/

55... EnglishAppendicesPin Assignments of D-Sub COMPUTER Input ConnectorMini D-Sub 15 Pin Connector1 2 3 4 511 12 13 14 156 7 8 9 10Signal LevelVideo

Power No power (POWER indicator does not light blue). Power cable’s plug is fully inserted into the wall outlet. No power even though you p

In the space below please describe your problem in detail.Information on application and environment where your projector is usedProjectorModel number

REGISTER YOUR PROJECTOR! (for residents in the United States, Canada, and Mexico)Please take time to register your new projector. This will activate y

© NEC Display Solutions, Ltd. 2013 7N952011

vEnglish ...Important InformationAbout High Altitude mode • Set [Fan Mode] to [High] when using the projector at altitudes approximately 2500 feet/

1... EnglishTable of ContentsTable of Contents...1Usage Notice ...2Precautions ...

2English ...Usage NoticePrecautions Follow all warnings, precautions and maintenance as recom-mended in this user’s guide to maximize the life of your