NEC Express5800/R110f-1E Manuale Utente Scaricare il pdf (Pagina 10)

Command Parameter Description

[-y]

Creates the Logical Drive immediately without displaying the message of

confirming that the Logical Drive may be created.

[Description]

Creates a Logical Drive with advanced parameter settings.

The raidcmd create a Logical Drive and terminates after Initialize is started. You can check the progress and

result of the Initialize by using "oplist" and "property" commands.

RAID Levels allowed to be created

RAID 0、RAID 1、RAID 5、RAID 6、RAID 10、RAID 50

Available Physical Devices

Physical Devices with [Status] of [Ready]

Physical Devices not used at all

Available Disk Array

Disk Array has empty area at the end. The RAID Level of the Logical Drive to be created must be the same as

that of the Logical Drive existing on the same Disk Array.

Configuration of Disk Array and Logical Drive to be created

Creates a single Disk Array and a single Logical Drive with the specified Physical Devices if the Disk Array is

created newly.

Capacity of Logical Drive with RAID Level of RAID 10 or RAID 50

For the RAID Level of RAID 10 or RAID 50, use the entire areas of Physical Devices to create a Logical Drive.

You cannot specify the capacities of the Physical Devices.

[Condition]

This command can be executed only in the Advanced Mode.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Nessun commento

NEC Express5800/R110f-1E Manuale Utente Pagina 10